Universal Remote Control R7 - SPECS SHEET Instrukcja Użytkownika Pobierz pdf (Strona 33)

Data Sheet ADP5586

Rev. 0 | Page 33 of 44

GPIO_INP_EN_B, Register 0x2A

Table 51. GPIO_INP_EN_B Bit Descriptions

Bits Bit Name Access Description

[7:5] Reserved Reserved Reserved.

4 GPIO_11_INP_EN Read/write 0 = GPIO 11 input disabled.

1 = GPIO 11 input enabled.

3 GPIO_10_INP_EN Read/write 0 = GPIO 10 input disabled.

1 = GPIO 10 input enabled.

2 GPIO_9_INP_EN Read/write 0 = GPIO 9 input disabled.

1 = GPIO 9 input enabled.

1 GPIO_8_INP_EN Read/write 0 = GPIO 8 input disabled.

1 = GPIO 8 input enabled.

0 GPIO_7_INP_EN Read/write 0 = GPIO 7 input disabled.

1 = GPIO 7 input enabled.

RESET_EVENT_A, Register 0x2B

Table 52. RESET_EVENT_A Bit Descriptions

Bits Bit Name Access Description

7 RESET_EVENT_A_LEVEL Read/write

Defines which level the first reset event should be to generate the RESET_OUT

signal.

For key events, use the following settings:

0 = inactive event used as a reset condition.

1 = active event used as a reset condition.

For GPIs and logic outputs configured for FIFO updates, use the following settings:

0 = not applicable; releases not used for reset generation.

1 = press is used as a reset event.

[6:0] RESET_EVENT_A[6:0] Read/write

Defines an event that can be used to generate the RESET_OUT signal. Up to three

events can be defined for generating the RESET_OUT signal, using

RESET_EVENT_A[6:0], RESET_EVENT_B[6:0], and RESET_EVENT_C[6:0]. If one of the

registers is 0, that register is not used for reset generation. All reset events must be

detected at the same time to trigger the reset.

RESET_EVENT_B, Register 0x2C

Table 53. RESET_EVENT_B Bit Descriptions

Bits Bit Name Access Description

7 RESET_EVENT_B_LEVEL Read/write

Defines which level the second reset event should be to generate the RESET_OUT

signal. Refer to Table 52.

[6:0] RESET_EVENT_B[6:0] Read/write Defines an event that can be used to generate the RESET_OUT signal. See Table 12.

RESET_EVENT_C, Register 0x2D

Table 54. RESET_EVENT_C Bit Descriptions

Bits Bit Name Access Description

7 RESET_EVENT_C_LEVEL Read/write

Defines which level the third reset event should be to generate the RESET_OUT

signal. Refer to Table 52.

[6:0] RESET_EVENT_C[6:0] Read/write Defines an event that can be used to generate the RESET_OUT signal. See Table 12.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Komentarze do niniejszej Instrukcji

Brak uwag

Universal Remote Control R7 - SPECS SHEET Instrukcja Użytkownika Strona 33

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Zdalne sterowanie Universal Remote Control R7 - SPECS SHEET