Universal Remote Control R7 - SPECS SHEET Instrukcja Użytkownika Pobierz pdf (Strona 18)

ADP5586 Data Sheet

Rev. 0 | Page 18 of 44

Figure 27 shows a typical multibyte read sequence for reading

internal registers. The cycle begins with a start condition followed

by the 7-bit device address (0x34), followed by the R/

bit set

to 0 for a write cycle. The ADP5586 acknowledges the address

byte by pulling the data line low. The address of the register

from which data is to be read is sent next. The ADP5586 acknowl-

edges the register pointer byte by pulling the data line low. A start

condition is repeated, followed by the 7-bit device address (0x34),

followed by the R/

bit set to 1 for a read cycle. The ADP5586

acknowledges the address byte by pulling the data line low.

Next, the 8-bit data is then read. The address pointer is then

incremented to read the next data byte, and the host continues to

pull the data line low for each byte (master acknowledge) until

the n data byte is read. The host pulls the data line high (no

acknowledge) after the last byte is read, and a stop condition

completes the sequence.

START

0 = WRITE

7-BIT DEVICE ADDRESS 7-BIT DEVICE ADDRESS

ADP5586 ACK

8-BIT REGISTER POINTER

READ BYTE 1 READ BYTE 2 READ BYTE n

0 0 0 1

0 0 0 0

REPEAT START 1 = READ

ADP5586 ACK ADP5586 ACK MASTER ACK MASTER ACK MASTER ACK

NO ACK

STOP

11148-027

Figure 27. I

C Multibyte Read Sequence

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Brak uwag

Universal Remote Control R7 - SPECS SHEET Instrukcja Użytkownika Strona 18