Universal Remote Control Thermo Control Instrukcje Operacyjne Pobierz pdf (Strona 12)

HOW TO REMOVE THE FILTER

LATCH

SCREW

AIR INTAKE GRILLE

AIR FILTER

ASI MODELS

CONDENSATE

DRAIN PAN

The inspection or replacement of internal components

involve the removal of the condensate drain pan.

Some metal edges and the vanes of heat exchanger are

sharp and may cause injury if handled improperly; be

especially careful when you clean these parts.

CAUTION

HOW TO REMOVE THE CONDENSATE DRAIN PAN

RUBBER CORK

CONNECTORS

CLIPS (2)

SUPPORT

PLATE (2)

SCREW (4)

SPECIAL SCREW (4)

1.Open the air intake grille.

2.Drain the condensate water into a bucket trough the

rubber cork that should be soon closed.

3.Remove the frame-grille assembly by loosening the four

special screws with washer; you can utilise the two clips

that fix the frame to the unit.

4.Disconnect the electrical connectors between the frame-

grille assembly and the unit.

5.Remove the four screws of the two support plates.

6.Grasp the two support plates, remove with care the

condensate drain pan and clean it inside, if necessary.

7.Once finished the maintenance, reassemble the pan,

aligning the side with the hole for condensate drain and

the side with the pump; insert the connectors of the unit

into the proper hole in the pan.

8.Fix again the four screws of the support plates and the

frame group aligning the corner from which the wires exit

and the corner with the connectors of the unit.

9.Mount the air intake grille along with the filter; be sure

that the safety string has been attached and that the latch

screw has been fixed on both sides.

ADDITIONAL MAINTENANCE (ONLY FOR ASI MODELS)

Washing the grille with water

●

Clean the grille gently using a soft sponge, or the like.

Then wipe away any remaining moisture.

●

Neutral detergent may be used to remove stubborn

dirt. Then rinse thoroughly with water and wipe away

any remaining moisture.

AIR FILTER

The filter behind thefront panel should be checked and

cleaned at least once every two weeks.

HOW TO REMOVE THE FILTER

1. Grasp both ends of the front panel and pull it towards you

and up.

2. Push the filter up slightly, and then take it out. Clean the

air filter and replace it.

Front panel

Air filter

AWI-FCI MODELS

1.Grasp both ends of the air intake grille and pull to open

it.

2.Hold the air filter by the tab and pull it upward. Clean the

air filter.

3.When replacing the filter, make sure that the FRONT

mark is facing you. Reinsert the filter into place and close

the air intake grille.

FCI MODELS

FRONT

The air filter should be cleaned at least once every six

months or more frequently; it depends on the real operation

conditions.

ASI-SDI MODELS

AWI MODELS

1 2 ... 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Universal Remote Control Thermo Control Instrukcje Operacyjne Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Zdalne sterowanie Universal Remote Control Thermo Control